Best current price£2.33from Professional Building Supplies
Shopping.co.uk recommended and popular offers
Professional Building Supplies£2.33Visit shop Floplast Grey Solvent Weld Waste Access Plug - 32Mm
Visit shop
Amazon£5.07Visit shop FLOPLAST Solvent Grey 32mm (36mm) Waste Access Plug
Visit shop17 offers from £2.33 - £10.80
View price history by clicking the chart icon.
The FloPlast Solvent Weld Waste Access Plug is designed for plumbers and DIY enthusiasts needing to create accessible points within waste plumbing systems for inspection and maintenance. Its primary benefit is providing a secure, permanent entry point into waste pipes, typically installed in a waste tee, facilitating easier cleaning and diagnostics. A key consideration is its specific requirement for 50mm solvent weld pipe and fittings, making it incompatible with pushfit or compression systems of the same nominal size.
| Brand | FloPlast |
|---|
This 50mm access plug is designed to fit into 50mm solvent weld pipe fittings. It requires a 50mm solvent weld socket to connect to.
No, this plug is specifically for solvent weld systems and is not compatible with pushfit or compression fittings, even if they are also nominally 50mm.
The access plug is inserted into a solvent weld fitting. For a permanent installation, the fitting itself is typically solvent welded onto the pipe. The plug then screws into this fitting.
No, this product is intended for waste water systems only and is not suitable for rainwater drainpipes, which require different types of fittings.
Solvent weld is a method of joining plastic pipes and fittings using a solvent cement that chemically fuses the materials together, creating a permanent and strong bond.
The joint should be left undisturbed for at least 5 minutes after assembly, and the system should not be tested or put into use for at least 12 hours to allow the solvent cement to cure fully.
The plug itself screws into the fitting. However, the fitting is permanently attached to the pipe via solvent weld. If you need to replace the plug or access the pipe beyond the fitting, you would typically need to cut the pipe and re-solvent weld a new fitting.
Verify that you are using a 50mm solvent weld fitting and that the access plug is also the correct size and type (solvent weld). Ensure no debris is obstructing the fitting or the plug.
The joint may not have been made correctly. Ensure surfaces were clean, solvent cement was applied evenly to both parts, and the pipe was fully inserted with a slight twist. Allow adequate setting time before testing.
Ensure the access plug is installed in an appropriate location (e.g., a waste tee) that allows access to the problematic section of pipe. Confirm the plug can be removed (note: removal typically requires cutting and re-joining).
Compatibility:
This 50mm access plug is designed exclusively for 50mm solvent weld waste pipe and fittings. It will not fit directly into a pipe. If your existing pipe or fittings measure 50mm externally and have 'PP' printed on them, they are likely incompatible and may require 50mm pushfit or compression fittings instead.
Installation (Solvent Weld Joint):
Important Safety Notes:
Care:
This product requires no specific care beyond ensuring the access point remains securely plugged when not in use. Periodically check the integrity of the plug and surrounding fitting.
