Draft Excluder Kit - B&Q

You can clean the draft excluder strip with a damp cloth. Avoid using abrasive cleaners or solvents, as they may damage the material or the adhesive.

This draft excluder is suitable for most standard interior and exterior doors with a flat bottom edge and a minimal gap to the floor. It adheres best to smooth surfaces like wood, metal, or painted doors.

No, installation is tool-free. You will only need scissors or a utility knife to cut the strip to the correct size if necessary.

The longevity of the adhesive depends on factors like door usage and environmental conditions. With proper installation on a clean surface, it should provide effective sealing for a significant period.

Yes, it can be used on exterior doors to help keep out drafts and improve energy efficiency. Ensure the surface of the exterior door is suitable for adhesive application.

This draft excluder is most effective on doors with a small to moderate gap. For larger gaps, you might need a more substantial draft proofing solution, such as a door sweep or a threshold seal.

When applied and removed carefully, it should not cause permanent damage to most door surfaces. However, on delicate finishes or previously damaged surfaces, test adhesion in an inconspicuous area first.

Ensure the door surface is thoroughly cleaned, dry, and smooth before application. Re-clean the area and try reapplying the strip, ensuring firm pressure is applied along its length.

The adhesive may have been compromised. Clean both the door surface and the back of the excluder strip. Reapply using firm, sustained pressure. For persistent issues, consider using a stronger adhesive suitable for both the door material and the excluder.

Measure the door accurately before cutting. If it's too short, you may need to purchase an additional kit or a longer alternative. If too long, trim carefully with scissors or a sharp utility knife for a neat finish.

Check if the gap under the door is too large for the excluder to create a full seal, or if there are gaps along the sides of the door. Ensure the excluder is pressed firmly against the door bottom and the floor/threshold.