Marshalls Standard Concrete Block Paving - Buff - 200 x 100 x 50mm

One pack of Marshalls Standard Concrete Block Paving (200 x 100 x 50mm) covers approximately 9.76 square meters.

It is recommended to blend blocks from 3 to 5 different packs during installation. This helps to distribute any slight shade differences evenly across the entire paved area for a more consistent finish.

Yes, it is recommended to order approximately 10% extra to account for cuts required during installation and potential breakages.

For standard driveways, the 50mm depth is often suitable. For areas with heavier traffic, it is recommended to consider the 60mm or 80mm depth options for enhanced durability.

The 'priora' block is a permeable paving option designed to allow rainwater to drain through the surface, helping to reduce surface water runoff and manage drainage.

Regular sweeping is advised. For cleaning, use water and a stiff brush. Mild detergent can be used for tougher stains, but avoid harsh chemicals or high-pressure washing.

Each Marshalls Standard Concrete Block Paving measures 200mm in length, 100mm in width, and 50mm in thickness.

This is a common characteristic of concrete products. Before installation, always blend blocks from 3-5 different packs and lay them randomly to achieve a more uniform appearance. If variations are significant, contact the supplier before installation begins.

Ensure the sub-base and laying course (sand) were adequately prepared and compacted. Uneven settlement often indicates insufficient groundwork. Adjust or re-lay affected blocks, ensuring the sand bed is even.

Ensure the blocks are dry and the joints are completely filled. Sweep kiln-dried sand into the joints repeatedly. Compaction of the paved area helps to settle the sand, but repeated sweeping may be necessary.

Efflorescence is a natural phenomenon in concrete products and is usually temporary. It will typically weather away over time. Avoid using acid-based cleaners, as this can exacerbate the issue. Sweep the area regularly.

This could indicate improper installation or the use of unsuitable cleaning methods. Ensure the sub-base is stable and avoid high-pressure washing. If wear is excessive beyond normal use, contact the supplier.