HydroSure WRAS Approved Male Adaptor Compression Fitting - 25mm x 1" - Pack of 3

Yes, the fitting is WRAS Approved, which means it meets the stringent standards for use in public water supply systems in the UK.

The fitting is designed to provide protection against leakage at working pressures up to 16 bar.

No, this fitting is specifically designed for 25mm (external diameter) MDPE or HDPE pipe only.

Basic tools like a pipe cutter and a wrench for final tightening are recommended. No specialized plumbing tools are typically required for this type of compression fitting.

WRAS (Water Regulations Advisory Scheme) approval signifies that the product has been rigorously tested and complies with UK water supply regulations, ensuring it is safe for use with drinking water and will not waste, misuse, or contaminate water.

The O-ring is made from durable, non-degrading material. When the pipe is inserted and water pressure is applied, the O-ring contracts tightly between the pipe wall and the fitting body, creating a secure, leak-proof seal.

The male thread size is 1" (one inch).

Ensure the pipe is fully inserted to the internal stop and the compression nut is tightened securely. Check the O-ring for damage or debris. Ensure the pipe is clean and has a square cut.

Make sure the pipe end is clean, free of burrs, and not deformed. Slightly twisting the pipe during insertion can help. Ensure the correct pipe diameter (25mm) is being used.

Verify the pipe material is compatible (MDPE/HDPE). Confirm the female threaded connection is clean and undamaged. Re-seat the pipe and tighten the compression nut again.