Floorsaver Concrete Dustproofer - 5 Litres
Best current price£29.00from Homebase
Best offers
Shopping.co.uk recommended and popular offers
Homebase£29.00Visit shop Floorsaver Concrete Dustproofer 5L
Visit shopHomebase£29.00Visit shop One Offer
1 offer from £29.00
View price history by clicking the chart icon.
Product Information
Full details
Floorsaver Concrete Dustproofer is designed for homeowners and contractors looking to eliminate dusting and surface degradation on concrete floors in garages or high-traffic areas. The key benefit is its deep-penetrating water-based acrylic formula that binds loose particles to create a durable, stain-resistant finish without leaving a maintenance-heavy surface film; however, it is important to note that this product acts as a surface hardener and stabilizer rather than a decorative aesthetic coating.
All features
| Brand | Floorsaver |
|---|
Extended Product Information
FAQs
Is this product suitable for outdoor use?
Yes, Floorsaver Concrete Dustproofer is formulated for both interior and exterior concrete surfaces.
Do I need to apply multiple coats?
A single coat is typically sufficient for most surfaces, but highly porous concrete may benefit from a second application to ensure complete stabilization.
Will this product change the color of my concrete?
No, it dries clear and does not leave a surface film, preserving the natural appearance of the concrete.
Can I paint over the concrete after using this?
Because the product is designed to harden and seal the surface, some paints may struggle to adhere; it is recommended to test in an inconspicuous area if you plan to paint later.
How long until I can walk on the floor again?
The quick-drying formula allows for light foot traffic shortly after the surface appears dry, but it is best to wait several hours for a full cure.
Troubleshooting
Surface remains dusty after application
This may indicate the concrete was too dense for full penetration or the first coat was insufficient. Ensure the surface is clean and consider a second application if the concrete is highly porous.
Liquid is pooling on the surface
The concrete has reached its saturation point. Use a broom or squeegee to push the excess liquid to untreated areas or remove the remainder to prevent surface spotting.
Pros and Cons
Pros
- Easy pour and sweep application method
- Water-based formula is safer and easier to clean up
- Suitable for both indoor and outdoor concrete surfaces
- Significantly reduces floor dusting
- Does not create a peeling surface film
Cons
- Not intended for use as a high-gloss decorative sealant
- Effectiveness depends on the porosity of the concrete
- Cannot repair deep structural cracks in concrete
Setup, Compatibility & Care
Before application, ensure the surface is entirely free of oil, grease, paint, or existing sealants, as these will block the product from penetrating the concrete pores. The concrete should be completely dry to achieve maximum absorption. No dilution is required for the standard formula. Once applied, allow the floor to cure according to environmental conditions before resuming full traffic. Because the product penetrates the material, no surface-level care or waxing is necessary. Simply mop the floor with clean water or a neutral detergent when needed.