Uponor Smatrix Wave T-169 Wireless RH Thermostat - White

It acts as a wireless room sensor to measure and transmit temperature and humidity data to a Smatrix Wave control module for managing radiant heating and cooling systems.

No, it is specifically designed to work with Uponor Smatrix Wave control modules and radiant heating/cooling systems.

The Uponor Smatrix Wave control system typically provides a low battery indicator when the CR2032 battery needs replacing.

This thermostat monitors humidity and can help prevent excessive humidity during cooling, but it does not actively control humidification devices.

'RH' stands for Relative Humidity, indicating the sensor's capability to measure and report the moisture content in the air.

IP30 means the device is protected against solid objects larger than 2.5mm (like a wire) and offers no protection against water. It is suitable for dry indoor environments.

It is recommended to check humidity settings seasonally or if you notice comfort issues, particularly when switching between heating and cooling modes.

Ensure the battery is correctly installed and charged. Check that the room sensor is within the wireless range of the control module. Re-initiate the pairing process according to the Smatrix Wave system manual.

Verify the sensor is not placed near heat sources (lamps, electronics) or in direct sunlight. Ensure the sensor is properly mounted and not obstructed. Allow time for the sensor to acclimate after initial installation or battery change.

Allow the sensor at least 30 minutes to acclimate to the room's humidity. Ensure the sensor vents are not blocked. Avoid placing the sensor near sources of high humidity like bathrooms or kitchens.

Confirm that the Smatrix Wave control module is powered and functioning correctly. Check the system settings and ensure the thermostat is assigned to the correct zone. Consult the Smatrix Wave control module's manual for advanced troubleshooting.