Edsyn Desolder Braid - 2.5mm - 15m
Best current price£34.09from eBay
Best offers
Shopping.co.uk recommended and popular offers
eBay£34.09Visit shop Edsyn Desolder Braid 2.5mm 15m
Visit shopeBay£34.09Visit shop All Offers
3 offers from £34.09
View price history by clicking the chart icon.
OnBuy.comEdsyn Sw 091/2.5/15 Desolder Braid 2.5Mm 15M 4016138095456
Free delivery in 1–3 days
£34.09
Visit shop
Rapid Online - Rapid Electronics Ltd.Edsyn SW 091/2.5/15 Desolder Braid 2.5mm 15m
Free delivery in 1–3 days
£34.09
Visit shop
Product Information
Full details
The Edsyn SW 091/2.5/15 desoldering braid is an essential tool for electronics technicians and hobbyists who require clean, efficient component removal during PCB rework. It excels at drawing molten solder away from joints through capillary action, leaving surfaces ready for re-soldering; however, users must exercise caution with temperature settings to avoid damaging delicate pads or traces.
All features
| Model Part Number | SW 091/2.5/15 |
|---|---|
| Brand | Edsyn |
Extended Product Information
FAQs
Can I use this braid with lead-free solder?
Yes, the Edsyn 2.5mm braid is fully compatible with both traditional leaded and modern lead-free solder alloys.
Does this braid require extra flux?
It is pre-impregnated with high-quality flux, but adding extra flux can sometimes improve results on oxidized or difficult joints.
How do I know when the braid is full?
You will visually observe the solder saturating the weave; once a section is silver-colored and rigid, it can no longer absorb more solder and should be cut off.
Is this safe for sensitive SMD components?
Yes, but use caution with heat settings to avoid thermal shock to nearby components or lifting the PCB pads.
How should I store the spool?
Store in a cool, dry, and clean environment. Keeping it in a sealed bag will help preserve the flux's activity over time.
Troubleshooting
Solder is not wicking into the braid
Ensure the iron temperature is sufficient and that you are heating the braid rather than the joint; adding a tiny drop of extra flux can also help.
Braid sticks to the PCB pad
Do not pull the braid while the solder is still cooling; ensure the joint is fully liquid before lifting the wick gently.
Braid is burning but not taking solder
Your iron temperature is likely too high, or you are holding the iron on the braid for too long.
Pros and Cons
Pros
- Excellent capillary action for rapid solder removal
- Pre-fluxed for immediate use without extra chemicals
- Generous 15-meter spool is cost-effective for frequent users
- Compatible with both leaded and lead-free solder
Cons
- Requires careful temperature management to prevent board damage
- Single-use tips require frequent trimming
- Not suitable for extremely fine-pitch micro-components under 1mm
Setup, Compatibility & Care
To ensure consistent performance, keep the braid stored in a cool, dry place to prevent flux oxidation. When using the 2.5mm width, ensure your soldering iron is set to a temperature appropriate for the solder type (typically 330-370°C for lead-free). Always trim the used, solder-filled section of the braid with side cutters before attempting to clean a new joint to ensure the wick's absorption capacity remains at its peak. Avoid leaving the spool in high-humidity areas, as moisture can degrade the effectiveness of the impregnated flux.