d-c-fix Self Adhesive Vinyl Film - Marble Grey Effect

The d-c-fix vinyl film is best suited for smooth, clean, and non-porous surfaces such as painted walls, laminate, sealed wood, glass, and metal.

Thoroughly clean the surface to remove all dust, grease, and dirt. Ensure the surface is completely dry and smooth. Any imperfections on the surface may show through the film.

Yes, for a short period after application, you can carefully peel back the film and reposition it. However, it's best to apply it slowly and deliberately to avoid the need for repositioning.

Clean the surface with a soft, damp cloth. Mild soap can be used for tougher grime, but avoid abrasive cleaners or scouring pads.

Each roll measures 2.1 meters in length and 90 centimeters in width.

While it can be used on surfaces in bathrooms, ensure all edges are well-sealed, especially around sinks and showers, to prevent moisture from seeping underneath the film. Proper sealing is key for longevity in humid environments.

No, this vinyl film is designed for smooth surfaces. Applying it to textured surfaces will result in poor adhesion and an uneven, undesirable finish.

Gently lift the edge of the film just before the bubble or wrinkle and reapply, smoothing with a squeegee. For stubborn bubbles, you can prick them with a fine needle and smooth out the air.

Ensure the surface is clean, dry, and smooth. Re-clean the surface and ensure no dust or grease is present. For older painted surfaces, a primer might be needed if the paint is unstable.

Use a sharp craft knife or precision blade and a cutting mat or ruler to guide your cuts for a clean edge.

Carefully align the pattern repeat. For seamless joins, it is sometimes necessary to overlap edges slightly or trim very precisely.