Ronseal Decking Protector - Natural - 5L

For optimal protection and to maintain your decking's appearance, it is generally recommended to re-apply annually, or as soon as you notice signs of wear or fading.

For best results, it is recommended to apply Ronseal Decking Protector to clean, bare wood. If your decking has existing coatings, these should ideally be removed (e.g., by sanding or using a decking stripper) to ensure proper adhesion and performance. Always perform a test patch first.

A 5-litre tin covers approximately 30-40m² with a single coat, based on the stated coverage of 6-8m² per litre. Actual coverage may vary depending on the porosity and condition of your decking wood.

You can apply a second coat after just 2 hours, making it possible to complete your project within a single day.

Yes, Ronseal Decking Protector is suitable for both softwood (e.g., pine, cedar) and hardwood (e.g., ipe, oak) decking, as well as smooth or ridged wood surfaces.

Simply clean brushes and pads immediately after use with warm water and household detergent.

Ensure the decking was thoroughly cleaned and free of all debris, previous treatments, and moisture before application. Stir the protector well before and during use. Apply a second coat after 2 hours for deeper colour and enhanced protection, ensuring even application.

Check the weather conditions during application. High humidity or low temperatures can significantly slow drying times. Ensure the product was applied thinly and evenly, avoiding thick coats or puddles. Ensure the wood was completely dry before application.

This often occurs due to uneven application or inadequate stirring. Always stir the product thoroughly. Apply along the full length of the boards, maintaining a 'wet edge' to prevent lap marks. Avoid applying in direct hot sunlight which can cause rapid drying and streaks.

Wipe up spills immediately with a damp cloth. If on paving, clean with water and detergent. For plants, rinse immediately with plenty of water. Always protect surrounding areas with sheets or tape before starting work.