NetAlly Test Accessory - TEST-ACC

The TEST-ACC primarily functions as an iPerf server and a PoE tester, designed to enhance the capabilities of compatible NetAlly network testers like the AirCheck G2 and LinkRunner G2.

No, the TEST-ACC is an accessory and requires a compatible NetAlly test device to operate. It does not function independently.

The product specifications indicate a built-in Lithium-Ion battery, but specific operational runtime is not detailed. It takes approximately 180 minutes (3 hours) to fully charge.

It supports a wide range of networking standards including IEEE 802.3, IEEE 802.3i, IEEE 802.3u, IEEE 802.3z, IEEE 802.3ab, IEEE 802.3af, IEEE 802.3at, and IEEE 802.3bt.

The TEST-ACC uses a standard RJ-45 connector for network connections.

The TEST-ACC measures 110.7 mm in width, 40.6 mm in depth, and 32.5 mm in height. It weighs 116 grams.

Yes, it has obtained compliance certificates for Electromagnetic Compatibility (EMC) and is FCC certified.

Ensure the Ethernet cable connecting the TEST-ACC to the tester is securely plugged in at both ends and is not damaged. Verify the tester is powered on and updated to the latest firmware.

Check the Ethernet cable quality and length. Ensure both the tester and the TEST-ACC are functioning correctly and not experiencing internal issues. Verify that no other network devices are consuming excessive bandwidth during the test.

Confirm that the device being powered and the TEST-ACC are correctly connected. Ensure the power source (switch/injector) is operational. Consult the NetAlly tester's manual for specific PoE testing error codes and their meanings.

Check if the TEST-ACC battery is charged. If the battery is depleted, connect it to a power source. If the issue persists after charging, contact NetAlly support.

Ensure the device is used within its specified operating temperature range (0°C to 45°C). Avoid prolonged use in direct sunlight or extremely hot environments. If overheating persists, discontinue use and contact support.