Draper Oil Filter Strap Wrench - 1/2" Sq. Drive

The Draper Oil Filter Strap Wrench can handle oil filters up to 120mm in diameter.

You can use either a 1/2" square drive or a 21mm wrench to operate the wrench.

Wipe the wrench clean with a cloth after each use to remove oil and debris. Ensure it's stored in a dry place to prevent rust.

The wrench is made from durable carbon steel with a zinc-plated finish.

While the strap is durable, it can wear out over time. Inspect it regularly and replace the wrench if the strap is damaged.

This wrench is designed specifically for oil filters. Ensure the filter size is compatible before attempting to use it.

Ensure the strap is properly positioned and tightened. Clean any oil from the filter surface. Use a different wrench if the issue persists.

Ensure the strap is correctly positioned and tightened securely around the filter. Check for any oil on the filter surface, which can cause slippage. Use a cleaner to remove any excess oil from the filter.

Apply penetrating oil to the filter threads and allow it to sit for a few minutes. Check that the drive tool (1/2" square drive or 21mm wrench) is properly connected and providing adequate leverage.

Inspect the strap before each use for signs of wear. If the strap is damaged, replace it immediately. Avoid excessive force when tightening the strap.