Bowl and Tray Template Router Bit Set - Saipor

These bits are compatible with density board, solid wood, MDF, particleboard, and splints.

The shank size for all bits in this set is 1/4 inch.

These bits are specifically designed for creating rounded indents, round nose plunging, and pattern/template routing. They are not intended for general-purpose edge profiling.

The Teflon coating helps prevent buildup. Clean the bits after use with a soft cloth to maintain their effectiveness and prevent resin from adhering.

The set includes bits with cutting diameters of 1/2", 3/4", and 1-1/8".

Yes, they are compatible with CNC routers, as well as table-mounted and handheld routers.

The cutting height for all bits in this set is 5/8 inches.

Ensure the bit is securely tightened in the collet and that the router's speed is appropriate for the wood type and bit size. Check if the wood is properly secured.

Clean the bit thoroughly to remove any buildup. Ensure the feed rate is consistent and that the bit is sharp. Verify the wood material is suitable for the bit.

Reduce the router's speed, decrease the depth of cut per pass, or ensure the Teflon coating is intact. Wood may be too soft for the speed being used.

Confirm that your router uses a 1/4 inch shank collet. If it does, ensure the collet is clean and free of debris. Check if the collet or the bit shank is damaged.