Setup, Compatibility & Care
Setup:
This is a bulk cable on a reel and requires termination with appropriate RJ45 connectors. Ensure you have the necessary tools, including an RJ45 crimping tool and compatible Cat5e FTP connectors. For optimal shielding performance, use connectors designed for shielded cable and ensure the drain wire is properly connected to the shield of the connector.
- Carefully unroll the required length of cable.
- Strip the outer PE jacket carefully without nicking the inner foil or conductors.
- Unshield the foil and straighten the drain wire.
- Arrange the 4 twisted pairs according to the TIA/EIA-568A or TIA/EIA-568B standard.
- Trim the wires evenly.
- Insert the wires into the RJ45 FTP connector, ensuring the foil and drain wire make contact with the connector's shield.
- Crimp the connector securely using the RJ45 crimping tool.
- Repeat for the other end, ensuring consistency in the wiring standard used.
Compatibility:
This Cat5e cable is backward compatible with Cat5 and forward compatible with Cat6 networks, though speeds will be limited by the lowest Cat rating in the chain. It works with standard Ethernet network devices, including routers, switches, network cameras, computers, and network-attached storage (NAS) devices.
Care:
- Store unused cable on the reel in a dry, protected location.
- Avoid sharp bends or kinks, especially during installation, as this can damage the solid conductors and shielding.
- While UV resistant, prolonged direct sunlight may eventually degrade the jacket. Consider using cable clips or conduits for extra protection in extreme conditions.
- Clean the exterior with a slightly damp cloth if necessary. Avoid harsh chemicals.