Best current price£23.08from Power Tools Direct
Shopping.co.uk recommended and popular offers
Power Tools Direct£23.08Visit shop Sealey 148Mm Da Backing Pad For Hook-And-Loop Discs M14 X 2Mm
Visit shop
B&Q£28.40Visit shop B&Q - 148mm Buffing & Polishing Backing Pad Hook & Loop Head Ptc/150Va/m14
Visit shop13 offers from £23.08 - £37.52
View price history by clicking the chart icon.
The Sealey PTC/150VA/M14 backing pad is designed for professional detailers and workshop technicians who require a reliable, high-precision interface for sanding and polishing tasks. This accessory offers the key benefit of a secure hook-and-loop attachment for 150mm discs, ensuring consistent surface contact for uniform material removal. While it provides excellent durability for power tools, users should note that it is strictly limited to tools featuring an M14 threaded spindle, meaning it is not compatible with standard drill chucks or non-threaded orbital sanders without an appropriate adapter.
| Model Part Number | PTC/150VA/M14 |
|---|---|
| Brand | Sealey |
While it may physically attach, it is designed specifically for 150mm discs to ensure proper balance and surface performance.
No, this pad requires an M14 threaded spindle found on professional polishers and sanders; it will not fit a standard drill chuck.
Yes, the construction is designed for durability, but ensure you clean and dry the pad thoroughly after wet operations to preserve the hook-and-loop surface.
Check your tool manual or look for the M14 designation on the spindle; M14 refers to a 14mm metric thread commonly used in European power tools.
Replace the pad if the hook surface becomes worn and no longer holds discs securely, or if the structural foam shows signs of cracking or crumbling.
Ensure the disc is pressed firmly onto the center of the pad. Check if the hook surface of the pad is clogged with sanding dust and clean accordingly.
Verify that the backing pad is threaded correctly and fully seated on the spindle. Also, ensure the sanding disc is perfectly centered on the pad.
Use a thin, flat wrench on the spindle flats of your power tool while holding the pad firmly to break the seal. Avoid forcing the pad with pliers.
To install, simply align the M14 thread of the pad with the spindle of your power tool and rotate clockwise until hand-tight. Do not over-tighten with tools, as this can make removal difficult. For care, always store the pad on a flat surface to prevent deformation of the foam or base material. Periodically inspect the hook-and-loop surface for debris or fiber buildup, and gently clean with a soft brush to maintain the adhesive integrity of your sanding discs.
