DeWalt Impact Torsion Bits - PH2 x 50mm - DeWalt

These bits are specifically designed for PH2 Phillips head screws.

Yes, they are compatible with any impact driver that accepts 1/4" hex shank bits.

The torsion zone allows the bit to flex, absorbing the impact energy and reducing the risk of breakage.

Clean the bits with a clean cloth after each use. Remove any debris to extend the lifespan.

The magnetic screwlock sleeve helps to hold the screw in place, making it easier to start and drive screws, especially in hard-to-reach places or overhead.

The lifespan of the bits depends on the frequency of use, the materials being worked on, and the technique. The torsion zone and full-fit head are designed for increased durability.

Stop using the bit immediately and try a new one. Worn bits can damage screw heads.

Ensure the bit is properly seated in the screw head and apply consistent pressure. Adjust the torque setting on your impact driver. Consider using a new bit if the head is worn.

Reduce the torque setting of your impact driver. Avoid excessive force. Ensure the bit is appropriate for the screw size and material. Check for any obstructions.

Clean the magnetic sleeve of any debris. Ensure the screw head is compatible with the sleeve. If the issue persists, consider using the bit without the sleeve or replacing the sleeve if possible.