Osma Stormline Ogee Guttering - 111mm - 8T874B

While the PVC-u material is UV stable and colored throughout, it is not recommended to paint it as modern paints may not adhere well to the surface and could trap heat, causing the plastic to expand and buckle.

Use a fine-tooth hacksaw. Ensure you deburr the edges after cutting to prevent damage to the seals during insertion.

Brackets should be installed at maximum 800mm intervals to ensure stability and load-bearing capacity.

This pack contains the gutter lengths. You will need to purchase the Ogee-specific stop-end outlets or running outlets separately to connect to your downpipe system.

Yes, the PVC-u construction is highly resistant to salt spray and atmospheric corrosion, making it suitable for coastal environments.

This system utilizes push-fit joints with pre-installed rubber gaskets. Ensure these are clean and properly aligned rather than using external sealants.

Check that the gutter ends are cut square and that the factory-fitted seals are free from debris and properly lubricated with silicone spray.

Re-adjust the bracket heights to ensure a consistent, slight gradient towards the downpipe. Ensure no brackets are loose or missing.

Check that the bracket spacing is correct (max 800mm). Install additional support brackets if the run is long or prone to snow loads.