Best current price£3.48from OnBuy.com
Shopping.co.uk recommended and popular offers
OnBuy.com£3.48Visit shop F-Type Screw Connector Splitter For Virgin Cable 2 Way 2.4G 5055383419036
Visit shop
B&Q£6.27Visit shop B&Q - F-Type Screw Connector Splitter For Virgin Cable 2 Way 2.4G
Visit shop3 offers from £3.48 - £6.27
View price history by clicking the chart icon.
This guide is for users needing to split an F-connector input signal, such as for connecting two satellite receivers or a receiver and a cable modem. Its key benefit is enabling simultaneous use of two devices from a single input. A potential caveat is that signal strength may be reduced when splitting, which could impact performance in fringe reception areas. This splitter features one F-connector input and two F-connector outputs, supports power pass-through on either output, and operates across a wide frequency range.
| Colour | Silver |
|---|---|
| Model Part Number | 001903 |
| Brand | kenable |
This splitter is specifically designed for F-connector satellite and cable TV signals and is not suitable for standard aerial (coaxial) TV connections.
Splitting a signal inherently divides its power. The reduction is generally minor for strong signals but can be noticeable on weaker signals. For very weak signals, consider a signal booster.
Power pass-through means that electrical power can be sent from the receiver through the splitter to the device connected to the dish (e.g., a motor for a movable dish). This splitter allows power to be passed through either output.
This splitter has one input and two outputs, allowing you to connect up to two devices to a single input source.
The frequency range supported by this splitter is from 5 MHz to 2450 MHz.
Yes, this splitter uses F-type screw connectors, which are compatible with Virgin Media cable systems that use this connector type.
Check all F-connector connections are tight. Ensure the incoming signal is strong enough before splitting. If the signal is weak, a splitter may not be suitable without a signal amplifier. Test by connecting one device directly to bypass the splitter.
Verify that power pass-through is functioning. Ensure the power cable to the dish is connected and operational. Confirm that the splitter's outputs are correctly configured for power pass-through if applicable to your dish setup.
Gently tighten the F-connector by hand. Avoid overtightening, which can damage the connector or the port. Ensure the cable's center conductor is not bent or damaged.
Setup:
Compatibility:
Care:
