Aisle Marking Tape - Red - 33m x 50mm

The tape adheres best to smooth, clean, dry, and non-porous surfaces such as sealed concrete, tile, linoleum, and sealed wood floors.

While durable, it is primarily designed for indoor environments. Prolonged exposure to direct sunlight, extreme temperatures, and moisture may affect its adhesive properties and longevity outdoors.

Clean the tape surface using a damp cloth. Mild soap and water can be used for tougher dirt, but avoid abrasive cleaners or solvents.

For optimal adhesion, it is recommended to apply the tape at room temperature, ideally between 15°C and 25°C (59°F and 77°F).

It is not recommended for use on very rough, unsealed, or textured surfaces, as adhesion may be compromised.

The tape measures 33 meters in length and 50mm in width.

While the adhesive is strong, it is designed to be removed. However, depending on the surface and how long the tape has been applied, some minor residue may be left. This can typically be cleaned with a mild adhesive remover or rubbing alcohol.

Ensure the surface is thoroughly cleaned, dried, and free of any contaminants. Apply the tape at an appropriate temperature and apply firm, consistent pressure during application.

During application, lift the tape slightly and reapply the affected section, ensuring the backing is removed smoothly and pressure is applied evenly. A credit card or squeegee can help push out small bubbles.

Apply additional firm pressure along the edges. If necessary, use a heat gun on a low setting for a few seconds to make the adhesive more pliable, then press firmly. Ensure the surface was properly prepared.

Gently heat the tape with a hairdryer or heat gun on a low setting to soften the adhesive. Carefully peel the tape back at a low angle. For any residue, a mild adhesive remover or rubbing alcohol may be used, testing in an inconspicuous area first.