Best current price£9.99from Amazon
Shopping.co.uk recommended and popular offers
Amazon£9.99Visit shop Topway Orange Tile Levelling System 50Pcs Pack Reusable Tile Levellers Spacers For Building Walls Floors + Special Wrench 347833
Visit shop3 offers from £9.99
View price history by clicking the chart icon.
The TOPWAY Multi Function Tile Levelling System is designed for DIY enthusiasts and professional tilers looking to achieve a perfectly flat, lippage-free surface on ceramic tiling projects. Its primary benefit is the reusable, screw-based mechanism that simplifies the leveling process and reduces project costs over time. A key caveat to keep in mind is that the spacers must be removed after the tile adhesive has fully cured, requiring careful timing to ensure clean extraction without damaging the fresh grout lines.
| Model Part Number | 347833 |
|---|---|
| Brand | TOPWAY |
Yes, it is designed for both wall and floor tiling applications.
Yes, the kit includes 50 sets of spacers and the tightening wrench.
You should wait until your tile adhesive has reached its initial set, usually following the manufacturer's recommendations for drying time.
This system is optimized for ceramic tiles. Check the thickness of your stone to ensure it falls within the 5mm-17mm range.
The system is sold as a complete set; for long-term use, ensure you clean the steel components thoroughly after every project.
Ensure that no thin-set mortar was allowed to dry around the steel pin. If it is stuck, gently tap the side of the spacer with a rubber mallet to break the mortar bond.
Check if there is sufficient mortar underneath the low tile. The leveling system can only correct slight variations; ensure the base is relatively level before installation.
Setup is straightforward: insert the steel pin through the tile gap, turn it 90 degrees to lock it under the edges of the tiles, and tighten the outer nut with the wrench.
Compatibility: This kit is specifically optimized for ceramic tiles between 5mm and 17mm thickness and grout lines from 1.5mm to 6mm. Always check your tile specifications before starting.
Care Instructions: After removal, immediately clean any excess mortar from the steel pins and screw threads using a damp sponge or a soft brush. Storing the components in a dry, organized container will prevent rust and ensure the threads remain easy to rotate for your next project.
