Kreg Precision Trak & Stop System - KMS8000

You will need a miter saw, radial arm saw, or drill press, and materials to build support wings (plywood or similar sheet material), along with basic tools like a saw, drill, and measuring tape.

The primary benefit is the ability to make precise, repeatable cuts without relying on a tape measure and pencil, increasing efficiency and accuracy.

Yes, it is designed to be compatible with most miter saws, radial arm saws, and drill presses. However, you will need to build your own support wings to mount the Trak system.

Carefully set the stop to the desired length using the precision lens cursor, and ensure the workpiece is firmly against the stop during the cut. Regular maintenance and calibration checks are also important.

Use a brush or compressed air to remove sawdust and debris from the Trak and stop. Wipe down with a clean cloth as needed.

It is best suited for repetitive cuts where accuracy is crucial, such as cutting boards to the same length for shelves, drawers, or cabinet components.

The lens cursors allow for precise alignment of the cut, ensuring accuracy from either side of the blade.

Check the stop's alignment and ensure it is securely mounted. Recalibrate if necessary. Check blade for any deviation.

Ensure the locking mechanism is not overly tightened. Clean the Trak and stop to remove any debris.

Double check the support wings are level and the entire system is securely positioned.