Moore & Wright Dial Caliper - 6in

The shockproof dial allows for quick and convenient zero setting, which is especially useful for taking multiple comparative measurements efficiently without losing accuracy.

The caliper is made of Stainless Steel with a blue anodized bezel.

This specific model has a measurement capacity of 6 inches or approximately 150mm.

Yes, dial calipers are designed to measure both external and internal dimensions, as well as depth.

It should be stored in its protective case to prevent damage, dust, and moisture. Ensure it is clean and dry before storage.

While it offers good precision for general use, for extremely critical laboratory work requiring micro-level accuracy, specialized instruments might be more appropriate. However, it is highly accurate for most workshop and engineering tasks.

Use a soft, dry cloth. For tougher dirt, a slightly damp cloth with water or mild cleaning solution can be used, followed by thorough drying.

Ensure the jaws are fully closed and clean. Check for any debris obstructing the movement. If the issue persists, the internal mechanism may need adjustment or servicing.

Clean the measuring surfaces (jaws) and the slide. Ensure the caliper is not being held at an angle during measurement. Verify the dial is properly zeroed before each new measurement set.

Clean the main beam and the slider. Check for any dirt or damage. A very light application of instrument lubricant on the slide may help, but avoid over-lubrication.

There is usually a small screw or tension mechanism on the bezel that can be adjusted. Refer to the specific model's details or consult a professional if unsure.