TRADEDOWNCO PEEL & STICK TILES - Classic White Subway

While the tiles are water-resistant, they are best suited for splashbacks and areas with occasional moisture rather than direct, prolonged water exposure like inside a shower enclosure. Ensure proper sealing of edges if used in very damp areas.

Yes, you can install them over existing smooth, glossy tiles. Ensure the old tiles are clean, free of soap scum, and well-adhered. Avoid installing over textured or uneven tiles.

Each pack contains 10 oversized vinyl tiles, each measuring 30 x 30 cm (approximately 12" x 12").

Yes, they are designed to be renter-friendly and can be removed. However, removal can sometimes damage the underlying paint or surface, especially if the surface was not properly prepared or painted with a low-adhesion paint.

No, these tiles are designed for walls and backsplashes only and are not durable enough for floor traffic.

Use a sharp utility knife or strong scissors. Measure carefully and score the vinyl before cutting for a clean edge. A cutting mat is recommended.

The tiles are heat-resistant and suitable for use behind a hob. However, avoid direct, prolonged contact with extreme heat sources, and ensure there is adequate ventilation.

Please refer to the product packaging or the retailer's website for specific warranty information, as warranty details are not provided in the product description.

Ensure the surface is thoroughly cleaned, dried, and smooth. Re-apply pressure to the tile. For difficult surfaces, consider using a spray adhesive specifically designed for vinyl or tile applications on the wall, allowing it to become tacky before applying the tile.

Carefully lift the edge of the tile and re-apply, smoothing outwards from the center. For small bubbles, you can try gently piercing the bubble with a fine pin and pressing flat.

Ensure you are overlapping the tiles correctly according to the design. If edges are uneven, you may need to trim carefully with a sharp blade. Ensure starting point is perfectly straight.

Press down firmly on the edges. If adhesion is poor, the surface may not be suitable. Ensure the surface is clean and dry. For a more permanent solution on suitable surfaces, a small amount of tile adhesive can be applied to the back of the tile edge.

Avoid using abrasive cleaning tools or harsh chemicals. Clean gently with a soft, damp cloth. Minor surface scratches may be unavoidable over time with heavy use.