Best current price£7.01from eBay
Shopping.co.uk recommended and popular offers
eBay£7.01Visit shop 16"" Ball Joint Splitter Forked Tie Rod End Separator Long Reach Breaker Remover
Visit shop4 offers from £7.01 - £14.99
View price history by clicking the chart icon.
The Tooltime 16 Inch Forked Ball Joint Splitter (AU176-TT) is designed for automotive technicians and DIY enthusiasts who perform frequent steering and suspension maintenance on cars and light commercial vehicles. Its primary benefit is the efficient, brute-force separation of ball joints and tie rod ends without damaging surrounding components, though it requires a separate hammer to operate and necessitates careful alignment to ensure joint integrity.
| Model Part Number | AU176-TT |
|---|---|
| Brand | Tooltime |
No, this tool is designed for manual hammer strikes. Using an air hammer can cause the metal to shatter or fail prematurely.
The total length of the tool is 400mm.
Yes, it is possible. This type of tool works by wedge pressure and often compromises the rubber boot. It is usually intended for parts you are replacing.
It is constructed from tempered drop-forged steel that has been heat-treated.
The tool is finished with a corrosion-resistant plating. Keeping it clean, dry, and stored in a tool chest will prevent oxidation.
Ensure the fork is seated deep against the stud and that the handle is held perfectly perpendicular to the joint assembly.
Verify the joint size is compatible with the 18mm opening; if the joint is larger, do not force the tool as it may cause metal stress.
Compatibility: The 18mm jaw opening is compatible with the majority of passenger cars and light commercial vehicle ball joints and tie rod ends. Ensure your specific vehicle's joint taper fits within the 18mm gap before beginning work.
Setup: No assembly is required. Before use, ensure the area is clear of debris. Position the fork ends snugly around the joint stud.
Care: To maintain the tool, wipe it clean of oil and grease after every use. While the tool is plated for corrosion resistance, storing it in a dry toolbox will further prevent rust. Inspect the fork edge periodically for signs of metal fatigue or chipping; if the edge becomes dull or damaged, it may cause the tool to slip during operation.
