PocketWizard Remote Cable - N3-ACC

The pre-trigger function allows the camera's shutter button to be held in a half-pressed state. This keeps the camera's autofocus and exposure metering systems active, significantly reducing the delay when you need to take a full press to capture the image.

No, this cable is specifically designed for Canon cameras that feature an N3 remote shutter release terminal. Please check your camera's specifications to confirm compatibility.

Yes, this cable is designed to work with compatible PocketWizard transceivers, such as the FlexTT5 and MultiMAX, which can control the pre-trigger functionality. Basic triggers may only offer simple shutter release.

The cable length is 0.915 meters (approximately 3 feet).

This cable is designed for controlling the electronic shutter release for still photography. It does not typically support initiating or stopping video recording on most Canon cameras.

The adapter ensures the correct signal conversion from the 3.5mm stereo output of the PocketWizard to the mono input required by the Canon N3 terminal, maintaining proper communication for shutter control.

Ensure the N3 connector is securely plugged into the camera and the 3.5mm connector is properly attached to the PocketWizard transceiver. Verify that the PocketWizard is powered on and correctly configured for remote camera control.

Confirm that your PocketWizard transceiver supports the pre-trigger function and that the correct remote zone is activated. Check that the camera's remote terminal is not obstructed and is clean.

This is expected when the pre-trigger function is actively maintained. If battery life is a concern, disable the remote zone on your PocketWizard when not actively shooting to allow the camera to enter its normal sleep modes.

Inspect the cable for any visible damage. Ensure both the camera's N3 port and the cable's connector are clean and free of debris. Try a different PocketWizard transceiver if available to rule out transceiver issues.