Knipex TwinForce High Performance Diagonal Cutter - 180mm

The patented double joint (Twinforce) provides significantly increased leverage, requiring up to 50% less effort to cut compared to traditional high-leverage diagonal cutters.

They are designed to cut soft wire (up to Ø 5.5mm), medium hard wire (up to Ø 4.6mm), hard wire (up to Ø 3.2mm), piano wire (up to Ø 3.0mm), and steel tape.

Yes, the reduced cutting effort and minimized impact make them ideal for repetitive cutting jobs, helping to reduce hand and arm fatigue.

Keep the blades clean, lubricate the joint periodically with machine oil, and store them in a dry place. Avoid harsh cleaning agents.

The cutting edges are induction-hardened to approximately 64 HRC for superior durability and sharpness.

No, these are wire cutters designed for solid wire and metal. They are not insulated and should not be used on or near live electrical circuits.

They are manufactured from chrome vanadium heavy-duty steel, which is oil-hardened and tempered for strength and durability.

The joint may need lubrication. Apply a small amount of machine oil to the pivot point and work the handles back and forth. Wipe off any excess oil.

Check the cutting edges for debris or damage. Clean thoroughly. If the edges are damaged or worn, professional sharpening might be needed, or the cutters may need replacement if severely compromised.

Ensure the pivot bolt is properly tightened (this is typically factory set). If the issue persists, there might be internal damage to the joint, and professional assessment or replacement may be necessary.

Ensure your hands are clean and dry. The molded handles and slip guards are designed for grip, but contamination can reduce their effectiveness. Inspect the handles for any damage or wear.