Bosch Tripod - MM 3

The product information does not specify a maximum weight capacity, but it is designed to securely hold standard Bosch cross-line lasers, which are relatively lightweight.

Yes, as long as the laser has a standard 1/4" tripod mounting thread, it should be compatible with the Bosch MM 3 Universal Clamp.

This range refers to the typical working area accessible by positioning the clamp itself on a surface. The clamp can be attached to surfaces within this height range from the ground or floor, and then the laser can be adjusted.

The clamp features a dedicated fine height adjustment mechanism that allows for 60 mm of precise vertical movement after the initial clamp position is set.

While durable, the clamp is primarily designed for indoor applications. It is not weather-resistant and should be protected from moisture and harsh environmental conditions.

The clamp has a width of 47 mm, a depth of 149 mm, and a height of 154 mm.

It is made using over 85% recycled plastics and is packaged in cardboard without any plastic polybags.

Ensure the surface is clean and flat. Tighten the adjustment knob firmly. Check if the surface thickness is within the 3-70 mm range.

Verify the clamp itself is mounted on a level surface. Use the fine height adjustment to make minor vertical corrections. Ensure the laser itself is functioning correctly.

Check for any obstructions. Lightly clean the pivot points. If it persists, ensure the laser is not exceeding the clamp's weight capacity (though the MM 3 is designed for typical cross-line lasers).