Fujifilm Instax Mini 12 Instant Camera - Blossom Pink

The Instax Mini 12 uses Fujifilm Instax Mini instant film, which produces credit-card sized photos.

Each Instax Mini film pack contains 10 exposures (photos).

An Instax Mini photo begins to develop immediately upon ejection, with colors appearing within 90 seconds. Full development typically takes 5-10 minutes, depending on the ambient temperature.

No, the flash on the Instax Mini 12 is automatic and cannot be manually turned off. It fires as needed to ensure optimal exposure.

The flash charging lamp (located next to the viewfinder) will blink slowly when the batteries are low. Replace both AA batteries when this occurs.

No, the Instax Mini 12 is not waterproof. Avoid exposing it to water, rain, or high humidity to prevent damage.

Store unused Instax Mini film in a cool, dry place, ideally at temperatures between 5°C and 40°C (41°F and 104°F). Keep it sealed in its original packaging until ready to use.

Check if the batteries are inserted correctly with the correct polarity. Replace with fresh AA alkaline batteries. Ensure the lens barrel is twisted to the 'ON' position.

Check if there is film loaded in the camera. Ensure the film compartment door is closed securely. If a new film pack was just loaded, the black protective sheet should have ejected first. If not, try powering off and on again. The film counter should indicate there is film.

Ensure you are shooting in appropriate lighting conditions. The Instax Mini 12 has automatic exposure, but extreme dark or bright environments can still be challenging. Avoid shooting directly into strong light sources (like the sun) or in completely dark rooms without adequate flash range.

Hold the camera steady while taking a picture. Ensure your subject is within the optimal shooting range (0.3m to infinity). If shooting close-up (30-50cm), ensure you have twisted the lens to the 'Close-up Mode' position.

The flash on the Instax Mini 12 fires automatically in most conditions to ensure proper exposure. If it doesn't fire, check battery level and ensure the camera is powered on. There is no option to manually turn off the flash.