Knipex Diagonal Cutters - 180mm

Their primary purpose is for making near-flush cuts on molded plastic components from sprues and for cutting soft materials like lead.

These cutters are not designed for cutting electrical wire, especially harder metals. They are optimized for soft plastics and lead.

Keep the cutting edges clean by wiping them after each use. Avoid cutting hard materials which can dull or damage the edges.

Flush cutting means cutting as close as possible to a surface, leaving minimal or no protruding material behind, resulting in a clean finish.

While Knipex tools are durable, the opening spring is an integrated part. If it fails, professional servicing or replacement of the tool might be necessary.

The 180mm length provides good leverage for cutting, and a comfortable reach for various tasks, balancing power with control.

They are best suited for removing smaller plastic parts from sprues. For cutting thicker or harder plastic sections, more robust cutters designed for that purpose would be recommended.

Check the pivot point for debris or rust. Clean the area and apply a small amount of light machine oil. Work the handles back and forth to distribute the oil.

Ensure the cutting edges are clean and free from plastic residue. Verify that the material being cut is within the cutters' intended capacity (soft plastics, not hard resins). Check for any nicks or damage on the cutting edges.

Inspect the spring mechanism for damage or obstruction. If the spring is damaged, it may need replacement by a qualified technician or the tool may need servicing.