Carplan Engine Paint - Matt Black - 250ml

Thoroughly clean the metal surface with a degreaser to remove all oil and grease. Remove any loose paint or rust. For optimal adhesion, lightly abrade the surface with fine-grit sandpaper.

Drying times vary based on temperature and humidity. Typically, it is touch-dry within 30-60 minutes and fully cured within 24-48 hours. Refer to the product label for specific recommendations.

This lacquer is primarily designed for metal engine parts. It is not recommended for use on most plastics, as it may damage or melt them. Always test on an inconspicuous area first if attempting to use on non-metal surfaces.

This specific product is a matt black engine lacquer. Please check the Carplan range for other available colors or finishes.

Coverage can vary depending on the surface and application thickness. A 250ml can is generally sufficient for touching up or painting several smaller engine components or a portion of a larger one.

Yes, provided the existing paint is sound, clean, and lightly abraded. If the existing paint is flaking or damaged, it must be removed completely before applying the new lacquer.

Ensure the can was shaken sufficiently and applied in thin, even coats from the correct distance. Avoid over-application in one pass.

The surface may not have been properly prepared. Clean the surface thoroughly to remove all traces of oil, grease, and old paint. Lightly abrading the surface before painting can improve adhesion.

Ensure the nozzle is not clogged. Try clearing the nozzle with a fine wire or by turning the can upside down and spraying briefly to clear any blockage. Ensure the can was shaken vigorously.

This may indicate a formulation variation or improper application. Ensure the correct product variant is being used and apply in thin coats to achieve the intended matt finish. Allow full cure time.