Best current price£18.00from OnBuy.com
Shopping.co.uk recommended and popular offers
OnBuy.com£18.00Visit shop Floor Pops Lillium Blue 30.48Cm X 30.48Cm Self-Adhesive Vinyl Floor Tiles 5056525367994
Visit shop
B&Q£24.97Visit shop B&Q - Floor Pops Lillium Blue 30.48 X 30.48Cm Self-Adhesive Vinyl Floor Tiles Pack 10 (0.93Sqm)
Visit shop3 offers from £18.00 - £25.49
View price history by clicking the chart icon.
The Floor Pops Vinyl Floor Tiles in LILLIUM BLUE are designed for homeowners looking for a quick, tool-free way to update their flooring with a stylish tiled look. They offer an easy DIY solution for refreshing kitchens, bathrooms, or any high-traffic area with a water-resistant finish. A key caveat is that they require a perfectly clean, flat, and smooth surface for optimal adhesion.
| Model Part Number | 5056525367994 |
|---|---|
| Brand | FloorPops |
Yes, but only if the existing vinyl is smooth, flat, and well-adhered. If it's textured, cracked, or peeling, it must be removed first.
Use a sharp utility knife to score the tile along your desired cut line. You can then carefully snap the tile along the score mark. For intricate shapes, multiple scores may be needed.
While water-resistant, they are not designed for constant submersion or areas with heavy water flow like a shower stall. They are best suited for splash zones or general flooring in bathrooms.
A 10x10 foot room is 100 square feet. Each pack covers 0.93 square meters, which is approximately 10 square feet. Therefore, you would need approximately 10 packs.
Yes, provided the concrete floor is properly sealed and primed according to the setup instructions. Ensure the concrete is dry and free of moisture issues.
The lifespan can vary depending on traffic and maintenance, but typically they offer several years of use in residential settings when installed correctly on a suitable surface.
No, linoleum is generally too soft and can be uneven, preventing proper adhesion. It's recommended to remove linoleum before installation.
Ensure the surface is perfectly clean, dry, and flat. Remove any dust, grease, or old adhesive. For concrete or wood, confirm a latex primer was applied and dried correctly. Press tiles down firmly, especially along edges.
This usually indicates insufficient surface preparation or installation on an incompatible surface. Clean the area, remove the tile, re-prepare the surface, and reapply with firm pressure. Consider using a primer if installing over bare wood or concrete.
Use a sharp, fresh utility knife blade. Score the tile multiple times along your marked line rather than trying to cut through in one pass. Use a straight edge as a guide. Practice on a scrap piece first.
If detected immediately, carefully lift the tile and re-apply, smoothing out any trapped air. If bubbles appear later, it may be due to moisture or adhesive failure. Ensure the subfloor is dry and the surface is properly prepped.
Setup: Ensure the target surface is hard, clean, and flat. Sweep and mop thoroughly, removing all dirt, dust, and debris. Allow the floor to dry completely. For installation over concrete or untreated wood subfloors, apply a thin, even coat of latex primer and let it dry according to the primer manufacturer's instructions.
Compatibility: Suitable for application on smooth, flat surfaces such as existing smooth ceramic tiles, finished wood flooring, or hardboard. Avoid installing over uneven surfaces like floorboards, floating floors, unsealed concrete, existing cracked tiles, vinyl with deep texture, linoleum, carpet, or floors with radiant heating.
Care: Clean spills immediately with a damp cloth. For regular cleaning, use a mild soap and water solution with a soft mop or cloth. Avoid abrasive cleaners or harsh chemicals, as they can damage the finish. Sweep or vacuum regularly to remove grit that could scratch the surface.
