JCP CONSTRUCTION PRODUCTS Shield Anchors - M10 x 60 - Silver

A4-316 stainless steel offers superior corrosion resistance, particularly against chlorides and acids, making it ideal for marine, coastal, and chemical environments.

These shield anchors are primarily designed for solid concrete and dense masonry. Their effectiveness in brickwork depends on the type and density of the brick; it is recommended to test or consult specifications for specific brick types.

You should use an M10 bolt or threaded rod with the M10 x 60 shield anchor. Ensure the bolt length is sufficient for your application after passing through the fixture.

Yes, provided the concrete or masonry substrate is adequate and the load calculations are performed correctly for overhead use, these heavy-duty anchors can be suitable.

Removing a shield anchor typically involves unscrewing the bolt. Once the bolt is removed, you may need to use pliers or a pry bar to carefully extract the shield body from the hole. If it is very firmly lodged, drilling it out might be necessary.

A4 stainless steel (like A4-316) has added molybdenum, which significantly enhances its resistance to pitting and corrosion, especially in chloride-rich environments, compared to A2 stainless steel.

Ensure the hole diameter and depth are correct for the M10 anchor. Verify that the bolt is being tightened correctly and is the appropriate size for the anchor.

The hole may be too large or not deep enough. Check the hole specifications. In some cases, a slightly larger anchor or different fixing method may be required.

While A4-316 is highly corrosion resistant, extreme conditions can still cause minor surface staining. Ensure no dissimilar metals are in direct prolonged contact. Clean gently if necessary.

The hole may be too small or contain debris. Ensure the hole is clean and has the correct diameter. Gently tap the anchor into place if needed.