Mains Inlet - Flush Fitting - White - PO114

This mains inlet is primarily used to provide a secure and flush-fitting external connection point for a 240V AC mains electrical supply, commonly found on caravans, motorhomes, and other vehicles or structures requiring external power.

Installation of mains electrical components should ideally be performed by a qualified electrician or someone with extensive experience in electrical wiring. Incorrect installation can pose serious safety risks, including electric shock or fire.

The Pennine PO114 measures 160mm in length, 105mm in width, and has a depth of 75mm. These are the external dimensions; the required cutout dimensions for flush fitting will be slightly smaller.

Yes, when properly installed and sealed with an appropriate weather-resistant sealant around its perimeter, the inlet is designed to withstand outdoor conditions and prevent water ingress.

This mains inlet is designed for 240V AC electrical systems, which is the standard voltage in many regions, including the UK and Europe.

The exterior can be cleaned using a soft, damp cloth and a mild detergent. Avoid using abrasive cleaners, solvents, or high-pressure washers, which could damage the finish or the seal.

This inlet is designed to accept standard 240V CEE form mains hook-up cables, commonly used for connecting to campsite electrical hook-ups or similar external power sources.

First, ensure the external power source (e.g., campsite hook-up) is active and functioning. Check your internal circuit breakers or RCD/MCB for trips. Verify that the mains lead connecting to the inlet is fully inserted and not damaged. Finally, inspect the internal wiring connections to the inlet for any looseness or disconnections (only if competent and safe to do so).

This often indicates a loose connection. Check that the external mains lead is securely plugged into the inlet. Internally, have a qualified person inspect the wiring terminals on the inlet for tightness and corrosion.

This is typically due to a compromised seal. Inspect the sealant applied around the perimeter of the inlet. Clean off any old, cracked sealant and re-apply a fresh bead of high-quality, weather-resistant sealant to create a watertight barrier.

Ensure you are using a standard 240V CEE form mains hook-up cable. Check the inlet's socket for any obstructions or damage. If damaged, the inlet may need replacement.