Cables Direct networking cable Grey 7 m - Cat6

Cat6 cables offer improved performance with higher bandwidth (up to 250 MHz vs. 100 MHz for Cat5e) and more stringent specifications for crosstalk and system noise, leading to faster and more reliable data transfer, especially for Gigabit Ethernet.

Yes, the Cables Direct ERT-607 is backward compatible. It will work with 10/100 Mbps ports, but it will operate at the maximum speed supported by the slower device, which would be 100 Mbps in this case.

No, this is a U/UTP (Unshielded Twisted Pair) cable. While the twisting of pairs helps reduce interference, it does not have an additional foil or braid shield, making it less suitable for environments with high electromagnetic interference.

24 AWG refers to the thickness of the copper conductors inside the cable. A 24 AWG wire is a standard size for Ethernet cables, balancing good conductivity with flexibility.

Please refer to the manufacturer's documentation or the retailer's product page for specific warranty information, as it is not provided in the product details.

While Cat6 cables are generally suitable for PoE, the UTP (unshielded) nature might affect performance or heat dissipation in high-power PoE applications compared to shielded variants. It's recommended to check the specific PoE requirements of your device.

Verify both ends of the cable are securely plugged into the correct ports. Check if the corresponding network lights on your devices are illuminated. Try a different Ethernet cable or port to isolate the issue.

Ensure the cable is not damaged (kinked, frayed). Check for potential electromagnetic interference near the cable's path. Confirm that both the device and the network port support Gigabit speeds (if expected). Test with a different Cat6 cable.

Inspect the RJ-45 connector for any visible damage or bent pins. Ensure there isn't any debris obstructing the port or the connector. If damaged, the cable may need to be replaced.