Confirmat Screws - 7x50mm - Grey

Confirmat screws are specifically designed for creating strong, rigid right-angle joints in wood-based materials like chipboard, plywood, and MDF, commonly used in furniture assembly.

Yes, pre-drilling pilot holes is highly recommended for optimal performance and to prevent splitting of the material, especially in denser wood-based panels.

The pilot hole size depends on the material. A general guideline is a bit slightly smaller than the screw's core diameter, but test on a scrap piece first. The thread should bite into the material.

No, these screws are engineered for wood-based materials and are not suitable for use in metal.

For a standard cabinet corner joint (e.g., side to top/bottom), two to four Confirmat screws are typically sufficient, depending on the size of the cabinet and the load it will bear.

This refers to the dimensions of the screw: 7mm is the nominal diameter of the screw body, and 50mm is the length of the screw.

Yes, the chrome finish provides a degree of corrosion resistance and a clean aesthetic.

Ensure you are pre-drilling a pilot hole of the correct size for the material. If using very hard wood, a slightly larger pilot hole may be necessary.

Verify that the pilot hole is not too large and that the screw is driven straight and fully into the material. Check that the material itself is not compromised.

Use the correct driver bit size and type (e.g., Pozidriv PZ2 or Hex) and ensure it is fully seated in the screw head. Apply consistent, steady pressure.