FloPlast Waste Socket Plug - 32mm

A socket plug, often called a cleaning eye, is used to gain access into a waste system for inspection and cleaning, or to blank off an unused pipe connection.

No, this socket plug has no seal and must be fitted into a compatible push-fit fitting such as a coupling or bend. It cannot be fitted directly into waste pipe.

This 32mm push-fit fitting is compatible with pipes that measure 32mm and are designed for push-fit systems. It is not compatible with 35mm pipes or fittings, or those marked 'ABS'.

Cut the pipe square, remove burrs, push the pipe fully into the fitting, and then withdraw it approximately 10mm to allow for expansion. Ensure the O-ring is correctly seated.

It signifies that the product has been independently tested and certified by the British Standards Institution (BSI) to meet relevant safety and quality standards.

Yes, the joints can be taken apart if required. However, always check that the O-ring has not been dislodged from its housing groove, as this can cause leaks.

This fitting is available in 32mm, 40mm, and 50mm size options. Note that the 50mm size is only available in grey.

Check that the pipe is cut square and free of burrs. Ensure you are using the correct size (32mm) and type (push-fit) of pipe and fitting.

Disassemble the joint and check that the O-ring is correctly seated in its groove within the fitting. Ensure the pipe end is clean and undamaged. Reassemble firmly.

Push-fit joints can be stubborn. Ensure the pipe is slightly withdrawn by ~10mm before attempting to disconnect. Specialized pipe removal tools may be helpful.