BOA Quick Change Diamond Tip Drill Bit - 10mm

The BOA 10mm Diamond Tip Drill Bit is designed for use in hard materials, including porcelain, granite, stone, and glass.

For optimal results, using the Boa CCV (Cool Clear Vision) guide and water cooling device is recommended. However, the bit is compatible with most standard drills.

Clean the bit after each use to remove debris. Store it in a dry place. Regularly inspect for wear.

The lifespan depends on usage and maintenance. Proper cooling and technique will extend the life of the bit.

Drilling speed should be adjusted based on the material being drilled. Slower speeds are generally recommended for hard materials.

Water cooling reduces heat buildup, preventing damage to the bit and the material being drilled, and extending the life of the bit.

The bit is manufactured in the UK.

Stop the drill immediately. Try reversing the drill to release the bit. If it remains stuck, check for obstructions.

Check if sufficient water cooling is being used. Ensure the drill speed is appropriate for the material. Check for any obstructions or damage to the bit.

Increase water flow or reduce drilling speed. Allow the bit to cool if needed. Ensure the bit is making proper contact with the material.

Reduce pressure. Use a lower drill speed. Ensure the bit is centered before drilling.