Bosch EXPERT Power Change Plus Arbor (SDS Plus)

The main advantage is the significantly faster bit change system, allowing you to switch accessories up to 5x faster than standard adapters, saving considerable time.

This arbor is specifically designed for use with the Bosch Power Change Plus system. While it works best with compatible Bosch hole saws, some third-party hole saws with the appropriate interface may also be compatible.

The centering drill bit ensures accurate starting points for hole saw cuts and can also be used for drilling pilot holes without needing to remove the arbor from the drill.

This arbor features an SDS Plus shank and requires a drill or hammer drill with an SDS Plus chuck for secure and efficient mounting.

After use, clear away any dust or debris from the arbor and the hole saw's connection point. A clean, dry cloth is typically sufficient. Store it to protect it from damage.

Yes, the robust design and rapid change system are engineered for the demands of professional use, enhancing efficiency on job sites.

The box typically contains the Expert Power Change Plus mounting, a centering drill bit (HSS-G, 7.15 x 45 x 85 mm), and an SDS Plus adapter.

Ensure the SDS Plus chuck is clean and properly engaged. Check for any debris in the chuck or on the arbor shank.

Verify that you are using a Bosch Power Change Plus compatible hole saw. Ensure the connection points on both the arbor and the hole saw are clean and free from obstruction. Make sure the hole saw is fully seated and twisted into the locked position.

Check if the centering drill bit is correctly inserted and secured within the arbor. Refer to the product manual for specific instructions on its attachment.

Clean the arbor and hole saw connection. Ensure the hole saw itself is sharp and suitable for the material being cut. Verify that the drill is operating at the correct speed and power setting.