Make Straight WC Pan Connector - PRO018

A straight WC pan connector is used to create a direct, in-line connection between the outlet of a toilet pan and the soil pipe, typically when the pipework aligns without any need for bends or angles.

No, this is a 'straight' pan connector and is designed specifically for direct, in-line installations. For angled pipework, an offset or angled pan connector would be required.

Ensure both the toilet pan outlet and the soil pipe are clean. Push the connector firmly onto both fittings, ensuring it is fully seated. If necessary, use a plumber's putty or appropriate sealant around the joint, following manufacturer guidelines.

These connectors are commonly made from durable, flexible plastics like PVC or rubber, designed to create a tight seal and withstand waste system conditions.

Yes, its straightforward design makes it suitable for DIY installation, provided basic plumbing knowledge and tools are available. Ensure correct measurements and a secure fit.

Once installed correctly, the connection should not require frequent checks. Regular toilet flushing will help maintain the system. Inspect for leaks only if you notice water or odors.

Ensure both the pipe and the connector's internal surface are clean. Apply a small amount of water-based lubricant or appropriate plumbing grease to the pipe end or the connector rim to ease insertion.

Check that the connection is fully seated on both the toilet pan outlet and the soil pipe. Ensure any applicable sealant or jointing compound has cured properly. If the leak persists, the connector may need to be replaced.

Verify that the connector is fully sealed on both ends and that there are no cracks or gaps in the connector itself or the surrounding pipework. Ensure the connection is not too far from the main trap of the toilet.