Deluxe Materials Super Phatic - 50ml - Red

Its primary advantage is its thin, low-odor formula that penetrates deeply, providing better joint strength on porous materials and offering easier cleanup with water before curing.

Yes, it is specifically recommended for bonding various types of foam, including polystyrene and depron, due to its penetrating qualities and compatibility.

Initial bond forms in 10-30 seconds. Full cure time can vary depending on materials, humidity, and temperature, but is typically within a few minutes to an hour for maximum strength.

It has low odor and is generally safer for indoor use than standard cyanoacrylates, but good ventilation is still recommended, especially for prolonged use.

Do not pull the skin apart. Soak the bonded area in warm, soapy water or nail polish remover (acetone). Gently try to ease the skin apart. For eyelids, seek medical attention.

Store upright in a cool, dry place, away from direct sunlight and heat. Ensure the cap is tightly sealed to prevent the glue from hardening in the bottle.

Yes, an accelerator can be used to speed up the curing process, which is particularly useful for non-porous materials or when a very fast bond is required.

Apply more sparingly. Use a jig or tape to hold parts in place while curing. Consider using an accelerator to speed up the bonding process.

Ensure surfaces are clean and dry. Apply sufficient glue for penetration. Ensure parts are held firmly during the curing time. Check if the glue has expired or been stored improperly.

Gently try to clear the nozzle with a pin or needle. If fully cured, a new bottle may be required.

Wipe away excess with a damp cloth or paper towel immediately after application, before it cures. For cured excess, carefully sand or scrape it away.