Draper Ball Joint Puller - 19mm

The Draper Ball Joint Puller has a jaw capacity of 19mm.

This puller is designed for most cars and some light commercial vehicles. Its 19mm capacity may be insufficient for heavy-duty truck applications.

Clean the tool after each use and lightly lubricate the thrust bolt threads to prevent rust and ensure smooth operation. Store in a dry place.

The puller features a forged body for strength and durability.

It is a direct action puller that uses a hardened thrust bolt to apply controlled force, separating the tapered ball joint stud from its socket.

The dimensions are approximately 16.90cm x 9.50cm x 4.40cm.

While effective, users should have a basic understanding of automotive suspension components and safety precautions. It requires manual force and careful application.

Ensure the jaws are positioned correctly and gripping the taper firmly. Check for any obstructions or damage on the ball joint stud or knuckle.

Verify the thrust bolt is centered and applying adequate pressure. Clean any rust or debris from the ball joint taper and knuckle seating. If the joint is severely seized, consider applying penetrating oil and allowing it to soak before retrying.

Clean and lubricate the thrust bolt threads. Ensure there is no debris or damage to the threads. Check that the puller is not over-extended or binding against other components.

Stop immediately. The jaw capacity may have been exceeded. Ensure the tool is appropriate for the specific task and vehicle. Inspect the puller for damage.