Washing Machine Sink Trap - 40mm x 75mm

The sink trap is made of high-quality white plastic.

The trap has two 40mm inlets (spigots) and is designed for 40mm pipework outlet.

Yes, it includes compression nuts, a tapered rubber seal, a rubber 'O' ring, and a slip ring.

While it has two spigots, it's typically designed for one washing machine and potentially another small drain. Check your local plumbing codes and the discharge rates of your appliances.

It's recommended to check and clean the trap periodically, especially if you notice slow drainage or odors. A visual inspection and wipe-down every few months is usually sufficient.

Yes, the P trap design creates a water seal that effectively blocks sewer gases and odors from entering your home.

While made of durable plastic, it is primarily designed for indoor plumbing systems. Exposure to extreme weather conditions may affect its longevity.

Ensure compression nuts are tightened evenly. Check that rubber seals and O-rings are correctly seated and not damaged. Reapply lubricant if necessary.

Verify that the trap is installed with the correct fall towards the drainpipe and that the drainpipe itself is not blocked.

Pour a gallon of water down the trap to refill the water seal. Ensure the trap is not dry due to infrequent use. Check for any cracks in the trap body or seals.

Ensure the correct size hose is being used. Check if any adapters are needed or if the spigot seal needs replacement.