Frys Metals Blowpipe Solder - Approx 1/2 Kilo

The product provides approximately 0.5kg of blowpipe solder in total.

The solder is supplied in thin strips, with each strip weighing approximately 58 grams.

While primarily designed for commercial applications, it can be used for larger electrical components where a robust joint is needed. For delicate electronics, a finer gauge solder might be more appropriate.

Any blowpipe or torch capable of reaching the appropriate melting temperature for the solder and the base metals being joined would be suitable. Ensure it provides a concentrated heat source.

Flux is often recommended for most soldering applications to ensure proper wetting and flow. Check product recommendations for specific applications or consider using a flux-cored solder if available and appropriate.

You can use a strong pair of shears or metal snips to cut the thin solder strips to the desired length.

Specific melting point information is not provided, but it is designed for blowpipe use, indicating a higher melting point suitable for robust commercial joining.

Ensure the metal surfaces are thoroughly cleaned and tinned. Verify that the blowpipe is providing sufficient heat and that the solder is being applied directly to the heated joint, not the flame.

Reheat the joint and ensure adequate solder flow. Check for contaminants on the metal surfaces or insufficient heat. Ensure the pieces being soldered are held securely while the solder cools.

Store the solder in its original packaging in a dry, cool environment. Avoid exposing it to humid air for extended periods.