Polypipe 110mm Equal Junction Triple Socket 87.5deg - Terracotta

This junction is designed for domestic underground drainage systems, allowing for the connection of multiple pipes at an 87.5-degree angle.

It uses a push-fit system with an integral seal and snap-cap for straightforward, secure jointing without the need for solvent cement.

It complies with BS EN 1401 and BS4660:2000 standards.

While it is a modern alternative to clay systems, it is designed to connect with other 110mm PVCu drainage pipes and fittings that meet the specified British Standards.

This fitting is specifically engineered for underground drainage applications. For above-ground drainage, different product specifications may be required.

The junction angle is 87.5 degrees, which is a common angle for transitioning pipes and ensuring good flow in drainage systems.

As this is a product guide based on provided information, specific warranty details are not available. Please refer to the manufacturer's official documentation or retailer for warranty information.

Ensure both the pipe spigot and socket are clean and dry. Apply silicone lubricant specifically designed for push-fit drainage joints to the spigot and the inside of the socket before attempting insertion.

The pipe may not have been fully inserted into the socket. Carefully release the joint (if possible without damage) and re-insert, ensuring it is pushed home fully. Check that the rubber seal is present and correctly seated within the socket.

This can occur if excessive force is used or if the fitting is subjected to impact. Ensure a clean, lubricated push-fit is used. If a crack occurs, the fitting must be replaced.