Easton EC70 AX Di2 Gravel Handlebar - 40cm - 31.8mm

Yes, but this specific model is optimized for Di2 internal routing, so verify that your mechanical housing can navigate the internal exit points.

The Easton EC70 AX is designed for a standard 31.8mm stem clamp diameter.

Check with the specific aero bar manufacturer regarding carbon handlebar compatibility, as some clamps can cause structural damage to carbon composite.

While weights vary by production run, the EC70 series is engineered for a competitive weight-to-durability ratio typical of mid-to-high-end carbon bars.

A torque wrench is strictly required for the safe installation of carbon components to prevent over-tightening and material failure.

Verify that you are using carbon-safe friction paste and that the stem bolts are torqued to the specific values recommended by the stem manufacturer.

Ensure the internal routing paths are free of debris and use a guide wire or thin cable to pull the electronic wires through the exit ports.

Remove the bars, clean the clamping surfaces thoroughly, apply fresh carbon paste, and re-tighten to the correct torque specifications.