Silverline Blacksmiths Drill Bit - 16mm

This drill bit is suitable for use on aluminum, steel, non-ferrous metals, plastic, and wood.

Yes, it is recommended to use cutting oil when drilling metallic materials to improve performance and extend the life of the drill bit.

The tip angle is 118 degrees.

The black oxide finish strengthens the surface of the drill bit, increasing its durability and resistance to wear.

Yes, the drill bit is compatible with both hand drills and drill presses.

Clean the drill bit after each use and store it in a dry place. Applying a thin layer of oil can help prevent rust.

The reduced shank (12.7mm) allows the drill bit to be used in standard drill chucks, which may not accommodate the full diameter of the bit.

Check the sharpness of the bit. Replace the bit if it is excessively worn or damaged.

Ensure you are applying appropriate pressure, using cutting oil (if drilling metals), and using the correct speed for the material. Check for any obstructions or damage to the bit.

Reduce the speed, apply cutting oil, and try retracting the bit periodically to clear debris. If necessary, use pliers to remove the bit carefully.

Check the drill speed and the pressure applied. Use a pilot hole before drilling to the full size and ensure the material is securely clamped.