R-TECH Premium Lead-Free Solder Wire - 0.7mm 100g

Lead-free solders typically have a higher melting point than traditional leaded solders. The exact melting point for this R-TECH solder is around 217-220°C (423-428°F), but specific temperatures may vary based on the alloy composition.

Yes, you can use this lead-free solder with a station designed for leaded solder, but you may need to set a slightly higher temperature to achieve proper flow due to the higher melting point of lead-free alloys.

'No-clean' flux residue is designed to be non-corrosive and electrically insulating after soldering, meaning it generally does not need to be removed. However, for critical applications or aesthetic reasons, cleaning may still be desired.

It is well-suited for general electronics soldering, PCB repair, and assembly where good joint strength and reliability are needed. For extremely sensitive applications where absolutely no flux residue is permissible, or where specific flux types are mandated, alternative solders might be considered.

Store the solder wire in its original packaging or a sealed container in a cool, dry place, away from moisture and direct sunlight to preserve the flux core's effectiveness.

22SWG (Standard Wire Gauge) is equivalent to approximately 0.71mm.

Ensure the soldering iron tip is clean and properly tinned. Increase the soldering iron temperature slightly if using lead-free solder. Check if the flux core is still active by heating a small amount of wire on a non-conductive surface.

This often indicates insufficient heat or oxidation. Ensure the workpiece is clean and heated adequately by the iron. Move the solder wire to the heated workpiece, not the iron tip.

Ensure adequate ventilation. While normal during soldering, excessive fumes may indicate the iron is too hot. Adjust temperature accordingly. Consider using a fume extractor.