Kidywolf Thermal camera

The camera uses thermal paper rolls for instant black and white printing. It comes with two standard rolls and one self-adhesive roll.

No, this camera prints photos in black and white using thermal printing technology.

Battery life can vary depending on usage, but it is rechargeable via USB-C for convenience.

No, an SD card is not included with the camera. You will need to purchase one separately if you wish to save digital copies of your photos.

The camera is recommended for children from 3 years old, with a minimum recommended age of 4 years.

The camera is charged using the included USB-C cable. Connect it to a suitable power source, such as a computer or a USB wall adapter.

The printed photos are thermal prints and are not inherently waterproof. They can be sensitive to heat and moisture. The camera itself has a 'Waterproof' protection feature listed, but this may refer to splash resistance rather than full submersion. It is best to keep the camera dry.

Ensure the camera is charged. Connect it to the USB-C cable and a power source. Check that the power switch is in the 'on' position.

Check if there is thermal paper loaded correctly in the printer compartment. Ensure the paper roll is not finished. Verify that the 'print' function has been selected after taking a photo.

Ensure the thermal paper is loaded correctly with the heat-sensitive side facing the print head. Replace the thermal paper roll if it is old or has been stored improperly. Clean the printer head gently according to care instructions if necessary.

Ensure the SD card is properly inserted into the slot. Try using a different, compatible SD card (ensure it is formatted correctly if needed, though the camera should handle this). Check if the SD card is full.

Try turning the camera off and then on again. If the issue persists, perform a soft reset if a reset button is available, or consult the manual for reset procedures. Ensure the battery is charged.