Luceco Era Solar Brick Light - Grey

Battery life depends on the selected lighting mode and the amount of sunlight the solar panel receives. The light is designed to operate through the night, especially in motion-activated or lower brightness modes, after a full day's charge.

Yes, the Luceco Era Solar Brick Light has an IP54 rating, making it resistant to dust and water splashes, suitable for year-round outdoor use.

The light uses an integrated rechargeable battery, which is designed to last for a significant period. Specific battery replacement details would typically be available in the product manual or through customer support.

Luceco offers a 2-year on-site support with a 1-year warranty on this product.

While you can install it, performance will be significantly impacted. For optimal operation, the solar panel requires direct, unobstructed sunlight for charging.

The light emits a 3000K white light, providing a warm white illumination.

Ensure the solar panel has received sufficient sunlight for charging. Check if the light is switched on (if applicable to the mode). Clean the solar panel. Test in a location with guaranteed direct sunlight for a full day.

Verify the light is in a motion-activated mode. Ensure the motion sensor is clean and unobstructed. Check that the detection range (up to 5m) is being met and that there are no obstructions between the sensor and the detection area.

The solar panel may not have received enough charge. Clean the solar panel. Ensure the panel is not covered by shade for extended periods. Check the battery's charge level (if indicated).

Check the selected lighting mode. The PIR sensor might be continuously triggered if placed near a heat source or in an area with constant movement. Reset the light if possible or consult the manual for mode selection.