Best current price£139.99from eBay
Shopping.co.uk recommended and popular offers
eBay£139.99Visit shop Sealey 3290CX Standard Chassis Trolley Jack 3 Tonne Compact Hydraulic Heavy Duty
Visit shop
B&Q£144.89Visit shop B&Q - Trolley Jack 3 Tonne 3290Cx
Visit shop5 offers from £139.99 - £156.32
View price history by clicking the chart icon.
This Sealey 3-tonne trolley jack is designed for professional use in workshops or for convenient roadside assistance, offering a compact and lightweight solution for lifting vehicles. Its key benefit lies in its ease of operation and portability, despite its robust lifting capacity. A potential caveat for some users might be its specific minimum and maximum lifting heights, which should be verified against your vehicle's requirements.
| Brand | Sealey |
|---|
The maximum saddle height is 465mm.
The minimum saddle height is 130mm.
The trolley jack weighs approximately 28kg.
It is suitable for light commercial vehicles up to its 3-tonne (3000kg) capacity. For heavier vehicles, a higher capacity jack would be required.
Turn the handle clockwise to close the release valve for lifting, and turn it counter-clockwise slowly to open the valve for lowering the load.
It is recommended to always use the jack on a firm, level surface. Using it on soft ground can be unstable and dangerous. Consider using a solid, flat board under the jack base if necessary.
Consult the Sealey product manual or contact Sealey customer support for the recommended type of hydraulic jack oil. Using the incorrect fluid can damage the hydraulic system.
Ensure the release valve is fully closed (turn clockwise). Check the hydraulic oil level and top up if low. If the problem persists, air may be trapped in the system; attempt to purge the air by opening the release valve slightly, pumping the handle a few times, and then closing the valve fully before attempting to lift again.
Check the hydraulic oil for contamination or leaks. Ensure the jack is on a level surface. If the issue persists, the hydraulic unit may require servicing or seal replacement.
Ensure the pump-through valve is not engaged. This valve prevents the handle from locking at maximum ram extension. Fully retract the ram and ensure the valve is not stuck.
Clean the castors and their bearings to remove dirt or debris. Lubricate the castor bearings if necessary.
Setup: The Sealey trolley jack typically requires minimal setup. Ensure the 2-piece handle is securely attached. Before first use, it is recommended to carefully operate the jack through its full range of motion without a load to purge any air from the hydraulic system. Always place the jack on a firm, level surface.
Compatibility: This jack is suitable for most passenger cars and light commercial vehicles with a Gross Vehicle Weight (GVW) up to 3 tonnes. Always consult your vehicle's owner manual for the correct jacking points and recommended lifting capacity. The minimum saddle height of 130mm means it may not be suitable for vehicles with very low ground clearance.
Care: Keep the jack clean and free from dirt and debris. Periodically check the hydraulic oil level and top up if necessary with appropriate hydraulic jack oil (refer to Sealey's recommendations). Inspect the ram, seals, and chassis for any signs of damage or leakage before each use. Store the jack in a dry environment, preferably with the ram fully retracted to protect the seals.
