Best current price£169.22from Professional Building Supplies
Shopping.co.uk recommended and popular offers
Professional Building Supplies£169.22Visit shop Sam Mouldings White Double Tongue Andamp; Groove Mdf Cladding - 294Mm X 4.88Mtr
Visit shop2 offers from £169.22
View price history by clicking the chart icon.
Designed for professionals and DIY enthusiasts looking to enhance interior or exterior aesthetics, this Double Tongue and Groove MDF Cladding offers a high-quality, fully finished white surface that minimizes installation time. It provides a sleek, uniform V-joint appearance that is both durable and low-maintenance; however, users should note that the 4.88m length requires careful planning for transport and handling to prevent surface damage during transit.
| Model Part Number | SAM004-064204 |
|---|---|
| Brand | SAM Mouldings |
This is an MDF-based product; it is not suitable for high-humidity areas or locations with direct water contact.
No, it comes fully finished in white, meaning it is ready to install immediately.
A standard power mitre saw or circular saw with a fine-toothed blade will provide the cleanest cut.
It is recommended to install a timber batten framework first to provide a level surface and an air gap for the cladding.
The board has a thickness of 12mm.
No, fixings are not included; we recommend using appropriate length wood screws or high-strength adhesive depending on your substrate.
Check the groove for dust or debris; ensure the board is held at the correct angle before sliding it into the tongue.
Use a white touch-up pen specifically designed for melamine or painted MDF finishes.
Ensure the sub-wall is perfectly plumb; tap boards gently using a rubber mallet and a sacrificial off-cut piece to prevent surface damage.
To begin installation, ensure your substrate is level and dry. Use a high-quality wood adhesive or secret-nailing technique through the tongue to keep the white face pristine. Since the product is fully finished, handle the boards with care to avoid scuffing the factory coating. If you need to make minor adjustments to the length, ensure your blades are clean and sharp. For cleaning, simply wipe the panels down with a soft, dry or slightly damp microfiber cloth. Avoid using harsh chemical cleaners or abrasive scouring pads, as these may damage the factory-finished white surface.
